Casablanca Fan Company K134F Folheto

e)  Locate the 2 wires from the switch housing cup labeled "lights". Remove plastic wire nuts from switch 

housing cup wires and strip 1/2" insulation from both wires (blue & white). Connect the wires from the 
switch housing cup to the wires from the light fixture: Blue to Black and White to White by placing the 
bare ends of the wires together and then secure with the wirenuts.

 

f)  Reconnect the 9 pin connector from the fan to the switch housing cover.
g)  Align switch housing cover with the bracket holes on the fan, making sure no wires are pinched in the 

process.

h)  Install the 3 screws removed in step 1a. Again, make sure that no wires are pinched in the process.
i)  Install glass (not included) by loosening the thumbscrews on each shadeholder, align glass inside shade-

holder as far as it will go and tighten thumbscrews equally around the glass. Make sure glass is snug and 
locked down tight so that the glass will not rattle the the fan is in operation.

 j)  Install appropriate light bulbs.
 

k)  Connect fob pull chain to light pull chain.

a)  Remove the switch housing cap by removing the two 8-32 screws. Save these screws for re-attaching cap.
b)  Remove plug from bottom of switch housing cap.
c)  Pass the wires from the light fixture through the outer hole of the switch housing cap, thread cap onto light 

fixture threads until tight.

d)  Locate the star washer & lock nut. Pass wires from light fixture through the star washer first, then the lock 

nut and thread on light fixture until tight.

e)  Locate the 2 wires from the switch housing labeled "lights". Remove plastic wire nuts from switch housing 

wires and strip 1/2" insulation from both wires (black or blue, and white).

f)  While holding light fixture up to the fan, attach the wires from the fan switch housing and the wires from the 

light fixture together. (

Black to Black or Blue to Black and White to White) by placing the bare 

ends of the wires together and then secure the wirenuts.

 

g)  Re-attach the switch housing cap with light fixture attached to the fan switch housing using the two 8-32 

screws removed in step 2a, insuring guide pins are properly located into switch housing.

 

h)  Install glass (not included) by loosening the thumbscrews on each shadeholder, align glass inside shadeholder 

as far as it will go and tighten thumbscrews equally around the glass. Make sure glass is snug and locked down 
tight so that the glass will not rattle when the the fan is in operation.

 i)  Install appropriate light bulbs.
 

j)  Connect fob pull chain to light pull chain.

2.  If your fan switch housing looks like this:

2