Casablanca Fan Company 6643Z Manual Do Utilizador

anama

Using Existing Ceiling Fixture Outlet Box

After turning the power OFF at its source (either

the circuit breaker or fuse box), lower the old fixture

and disconnect the wiring. Check the ceiling fixture

outlet box to be sure it is marked “Approved for

Ceiling Fan Mounting.” If it is not, a new box must

be installed.

GeTTING STarTeD

Installing a New Ceiling Fixture Outlet Box

If you do not have an existing fixture located where

you wish to place your Casablanca fan, an ap-

proved ceiling fixture outlet box must be installed

and wired.

Note: The weight of this fan is 24 to 26 pounds,

depending on model.

WARNING!

To reduce the risk of fire, electrical shock, or

personal injury, mount to outlet box marked

“Acceptable Fan Support of 22.7 kg (50

lbs.) or less” using the mounting hardware

provided with the outlet box.

Ceiling Hardware (not to scale)

WARNING!

Support directly to building structure only.

CroSSBar MoUNTING BraCkeT INSTaLLaTIoN

Note: after removing the old fixture, check the outlet

box to insure that it is supported by a joist or beam

across its upper surface. If not, a 2 x4 stud must be

installed.

Step 1a� Remove the knockout plug in the center

of the outlet box or drill a

-inch hole for the lag

screw to pass through. Then drill a

-inch guide

hole into the joist or beam to a depth of 3 inches.

Step 1b� Route the outlet box wires through the

keyhole slot of the crossbar mounting bracket as

shown. Attach the crossbar mounting bracket to the

outlet box with the screws provided, making sure

the outlet box wires are not pinched by the washer.

CAUTION:

To reduce the risk of personal injury, use only

the mounting hardware provided with the

approved outlet box to install the crossbar

mounting bracket.

Crossbar Mounting Bracket

Lag Screw and Washer (1)

1" x 8-32 Roundhead Screw and Washer (2)

" x 8-32

Roundhead Screw

(2)

Wire Nut (4)

Joist

Ceiling-Fan-

Approved

Wiring Box

Ceiling Wiring

Crossbar

Mounting Bracket

Green Ground Wire

Ridge side down

1" x 8-32

Roundhead Screw

Washer

faN INSTaLLaTIoN

CAUTION:

Damp Location rated fans required a Ground

Fault Interrupter(GFI). use a weather-proof

outlet box, properly connect ground wires,

and use only under a weather-proof structure