Casablanca Fan Company #C18G500FPOMONA Manual Do Utilizador

Atria

™

19

Installing the Light Fixture

Attaching the Light Fixture

1

 Locate and remove the pre-installed wire nuts on 

the motor housing wires.

2

 To attach the light fixture wires to the motor 

housing wires, match the wire colors as described 
below, hold the bare ends of the wires side by side, 
and fully insert the wires into the wire nut. Secure 
by rotating the wire nut in a clockwise motion. 

Connect wires in the following order:

WHITE wire from the fan to the WHITE 

•

wire from the light fixture 

BLUE wire from the fan to the BLUE 

•

wire from the light fixture 

Inspect each wire nut to ensure that no bare wire is visible. 
Test the connection by gently pulling on the wires. The wire 
nuts should stay firmly in place, covering the bare ends.

3

 Carefully coil or tuck the wires so they are not 

pinched. Locate the four mounting holes in the light 
fixture and align the four holes of the light fixture to 
motor housing with the two screws pre-installed on the 
motor housing. Then rotate the light fixture clockwise, 
locking it to the bottom of the fan. Once the light 
fixture has been mounted to the bottom of the fan as 
shown in Step 3, install the remaining two screws, then 
tighten all four screws with the provided screwdriver.