Casablanca Fan Company C10GXXM Manual Do Utilizador

INSTALLATION INSTRUCTIONS

CEILING HARDWARE

GETTING STARTED

Installing a New Ceiling Fixture Outlet Box

If you do not have an existing fixture located where you

wish to place your Casablanca fan, an approved ceiling 

fixture outlet box must be installed and wired.

After turning the power OFF at its source (either circuit 

breaker or fuse box), lower the old fixture and disconnect

the wiring. Check the ceiling fixture outlet box to be sure

that it is marked ‘Approved for ceiling fan mounting’.

If it is not, a new box must be installed. 

Warning: To reduce the risk of fire, electrical

shock,  or  personal  injury,  mount  to  outlet  box 

marked acceptable for ceiling fan support using 

the mounting hardware provided with the outlet 

box. Using Existing Ceiling Fixture Outlet Box

CROSSBAR MOUNTING BRACKET INSTALLATION

Step 1. To install the crossbar mounting bracket, route 

the outlet box wires along side of the crossbar mounting 

bracket.  Attach  the  crossbar  mounting  bracket  to  the 

outlet box with the set of two round-head screws and 

washers.  Use  caution  when  installing  the  screws  and

washers. Do not pinch the outlet box wires in the wash-

ers. Tighten the screws firmly by hand only, being careful

not to bend the bracket by over tightening.

Step  2.  To  install  the  lag  screw,  slide  the  remaining 

washer onto the lag screw. Pass the lag screw through

the center hole in the crossbar mounting bracket. Se-

cure the lag screw into the guide hole, tightening until 

the ceiling fixture outlet box is firmly mounted to the

support beam.