American Standard 6035 Manual Do Utilizador
M 9 6 8 4 1 6 R E V 1 . 1
Certified to comply with ANSI A112.18.1M
6035
1
REMOVE EXISTING
SHOWER HEAD
SHOWER HEAD
2
INSTALL PIPE NIPPLE
Tools required for installation:
Adjustable Wrench
ROUGHING-IN DIMENSIONS
Designer Shower
Massage System
Massage System
8AHJE5F=
™
Installation
Instructions
Thank you for selecting American-Standard...the benchmark of
fine quality for over 100 years.
fine quality for over 100 years.
25-7/8"
4-3/8"
38-1/8"
3-5/8"
3"
8-5/8"
9-3/4"
UP AND DOWN
ADJUSTMENT
UP AND DOWN
ADJUSTMENT
11-3/4 MAX."
6-1/4 MIN."
37-5/16"
MTG. HOLE
REFERENCE
10'
Level
Tape
Measure
Measure
5/16"
Drill Bit
Drill Bit
Drill
Phillips Screwdriver
Using an adjustable wrench or channel
locks, remove the existing Shower Head,
Arm and Flange (1) by turning
counter-clockwise.
locks, remove the existing Shower Head,
Arm and Flange (1) by turning
counter-clockwise.
Figure 1.
Apply Teflon tape (provided) to the end of the PIPE NIPPLE (1).
Figure 2.
Thread PIPE NIPPLE (1) into elbow fitting, using adjustable wrench
and tighten. Then, using a hacksaw, cut off excess PIPE NIPPLE (1) at the 3rd
groove from the finished wall. Discard the excess pipe and remove any burrs and
debris from the nipple.
groove from the finished wall. Discard the excess pipe and remove any burrs and
debris from the nipple.
Figure 3
. Install O-RING (2) into groove next to finished wall. One extra
O-RING (2) is provided in parts bag.
1
1
EXCESS PIPE
NIPPLE
MAKE CUT AT 3rd
GROOVE FROM
FINISHED WALL
GROOVE FROM
FINISHED WALL
1
2
3
Figure 2
Figure 3
Teflon
Tape
Tape
FINISHED WALL
FINISHED
WALL
1/2" NPT
Figure 1
Hacksaw
Hacksaw
65" TO 78"
TO FINISHED FLOOR
(OPTIONAL)
Channel Locks
Channel Locks
Adjustable Wrench
To ensure that your installation proceeds smoothly--please
read these instructions carefully before you begin.
read these instructions carefully before you begin.
2