MTD 31AE640F352 Manual Do Utilizador

11

•

Insert ferrule into the upper hole in shift lever. 

•

Reinstall the hairpin clip and the washer.

 Check for correct adjustment of the shift 

lever  as instructed on page 10, before operating the 
snow thrower.

The space between the shave plate and the ground can 
be adjusted. For close snow removal, place skid shoes 
in the low position. Use middle or high position when 
area to be cleared is uneven. 

•

Adjust skid shoes by loosening the four hex nuts 
and carriage bolts and moving skid shoes to 
desired position. See WARNING:.

•

Make certain the entire bottom surface of skid shoe 
is against the ground to avoid uneven wear on the 
skid shoes. Retighten nuts and bolts securely.

Do not operate this snow

thrower on gravel as loose gravel can be
easily picked up and thrown by the auger
causing injury to the operator and/or damage
to the snow thrower.

The wheels may be adjusted for two different methods 
of operation. The adjustment is made by placing the 
click pins in one of two different holes on the right side 
of the unit. See Figure 10.

One Wheel Driving: Insert the click pin only 
through the outside hole of the axle (not the rim) on 
the right side of the snow thrower. This position 
gives power drive to the left wheel only, making the 
unit easier to maneuver.
Both Wheels Driving: Insert the click pin through 
the hole in the hub of the rim and the inside hole on 
the snow thrower’s right axle. This position is good 
for heavy snow as there is power drive in both 
wheels.

 Never operate the snow thrower with the 

click pin inserted through both the rim and the outside 
hole in the axle. Doing so can result in serious damage 
to the drive system.