Ariens 916003 AMP 24 Manual Do Utilizador

GB - 13

See Figure 10 for all Controls and Features 
locations.

When attachment clutch and then traction 
drive clutch are engaged, the attachment 
clutch will remain engaged (lever down) if 
released. To stop attachment, release traction 
drive clutch and both clutches will disengage.

Squeeze the traction drive 
clutch lever against the 
handlebar (1) to engage 
wheel drive for propelling 
unit. Forward speed will 
vary according to snow 
depth and moisture 
content. 

Release lever (2) to stop 
movement.

NOTE: When traveling to or from the area to 
be cleared, press down on the handlebars 
enough to raise the front of the unit slightly off 
the surface. Engage the traction drive clutch 
without engaging the attachment drive clutch.

Squeeze Attachment 
Clutch Lever against 
handlebar (1) to 
engage attachment. 
Release both clutch 
levers (2) to disengage 
power and apply brake 
to attachment.

IMPORTANT: If the belt squeals when the 
attachment clutch lever is engaged, the 
impeller may be frozen in the auger housing. 
Immediately release the attachment clutch 
lever and move the unit into a heated area to 
thaw.

NOTE: If belt squeals when impeller turns 
freely, see Attachment Drive Belt 
Replacement on page 23.

Operate power switch 
with a removable key. 
Power switch has two 
positions: ON (1), and 
OFF (2).

Always remove key 
when unit is 
unattended or 
connected to battery 
charger.

When the 
power 
switch is in 
the ON 
position 
one LED 
will light, 
indicating 
the relative 

charge remaining in the batteries. When the 
batteries are fully charged (1) LED 10 or 9 will 
be lit.

During operation the lit LED will change, 
moving down the indicator scale as the 
batteries discharge.
When the batteries charge are nearly 
depleted (0) LED 1 and 2 will flash alternately.

NOTE: The battery level indicator will only 
reset once the batteries have been fully 
charged.

Pull out to start 
drive motor (1) and 
push in to stop 
drive motor (2).

WARNING: AVOID INJURY. Read 
and understand the entire Safety 
section before proceeding.

WARNING: To avoid injury to hands 
and feet, always disengage clutches, 
move PTO and power switches to 
OFF position, and wait for all 
movement to stop before unclogging 
or working on snow thrower.
Keep hands and feet away from 
auger and impeller.

OL2701

1

2

OL2691

1

2

1

2

1

2