Ariens 916003 AMP 24 Manual Do Utilizador

GB - 20

IMPORTANT: Damage to auger/impeller 
housing will result if blade wears down too 
far.

Scraper blade is adjustable to compensate 
for wear.
To adjust scraper blade:

1. Tip unit back onto handlebar, support 

housing and loosen nuts retaining 
scraper blade.

2. Adjust skid shoes to fully raised position 

(housing closest to ground). 

3. Reposition scraper blade flush with skid 

shoes and tighten lock nuts. 

Skid shoes should be adjusted as conditions 
require (Figure 18).

1. Position unit on a hard, flat, smooth level 

surface. 

2. Adjust skid shoes by inserting a spacer 

of desired thickness under center of 
scraper blade.

3. Loosen skid shoe hardware.
4. Slide skid shoe to flat surface. Allow 

1/8 in. (3 mm) between scraper blade 
and hard smooth surfaces. Allow 1-
1/4 in. (30 mm) between scraper blade 
and uneven or gravel surfaces. 
Retighten hardware.

NOTE: Keep housing level by adjusting skid 
shoes equally.

OS2602

= Grease

Figure 17

OS2603

WARNING: AVOID INJURY. Read 
and understand the entire Safety 
section before proceeding.