Ariens 916003 AMP 24 Manual Do Utilizador
GB - 8
PACKAGE CONTENTS
ASSEMBLY
Tools Required:
•
Pliers
•
Hex Key (Included)
•
Open-End Wrenches: 3/8, 7/16, 1/2,
9/16 in. and/or Adjustable Wrench
9/16 in. and/or Adjustable Wrench
•
Tire Gauge
Unfold Handlebar
1. Remove the lower and loosen the upper
hardware on the handlebar assembly.
2. Loosen the hardware on the shift rod.
3. Put the speed selector lever in the sixth
3. Put the speed selector lever in the sixth
forward position.
4. Rotate the handlebars into operating
position.
NOTE: Be careful not to damage cable spring
hooks when rotating handlebars upward.
hooks when rotating handlebars upward.
5. Install and tighten the hardware on the
handlebar assembly.
6. Tighten the hardware on the shift rod.
Make sure that the rod is correctly
seated before tightening.
seated before tightening.
.
ASSEMBLY
WARNING: AVOID INJURY. Read
and understand the entire Safety
section before proceeding.
and understand the entire Safety
section before proceeding.
WARNING: Dropping or tipping over
boxed unit could result in personal
injury or damage to unit.
boxed unit could result in personal
injury or damage to unit.
Figure 3
1. Sno-Thro
Unit
2. Discharge
Chute
3. Chute Crank
4. Hex Key
5. Literature
5. Literature
Pack with
Extra Shear
Bolts
Extra Shear
Bolts
Figure 4
OS2515
1. Shift Rod
2. Upper and Lower Handlebar
2. Upper and Lower Handlebar
Hardware
3. Shift Rod Hardware
4. Handlebar
4. Handlebar
OS2520