Ariens 932511 - ST624 Manual Do Utilizador
GB - 18
1. Position unit on a hard, flat, smooth level surface.
2. Adjust runners by inserting a spacer of desired
thickness under center of scraper blade, loosen
runner hardware, slide runners to flat surface.
Allow 1/8 in. (3 mm) between scraper blade and
hard smooth surfaces. Allow 1-1/4 in. (30 mm)
between scraper blade and uneven or gravel
surfaces. Retighten hardware.
runner hardware, slide runners to flat surface.
Allow 1/8 in. (3 mm) between scraper blade and
hard smooth surfaces. Allow 1-1/4 in. (30 mm)
between scraper blade and uneven or gravel
surfaces. Retighten hardware.
NOTE: Keep housing level by adjusting runners
equally.
equally.
SCRAPER BLADE
IMPORTANT: Damage to auger/impeller housing will
result if blade wears down too far.
result if blade wears down too far.
Scraper blade is adjustable to compensate for wear.
To adjust scraper blade:
1. Tip unit back onto handlebar, support housing
and loosen nuts retaining blade.
2. Adjust runners to fully raised position (housing
closest to ground).
3. Reposition scraper blade flush with runners and
tighten lock nuts.
SHEAR BOLTS
IMPORTANT: Use only Ariens shear bolts for
replacement. Use of any other type of shear bolt may
result in severe damage to unit.
replacement. Use of any other type of shear bolt may
result in severe damage to unit.
Occasionally a foreign object may enter the
auger/impeller housing and jam the auger, breaking
shear bolts (Figure 15) which secure the auger to the
shaft. This allows auger to turn freely on the shaft
preventing damage to gear drive.
auger/impeller housing and jam the auger, breaking
shear bolts (Figure 15) which secure the auger to the
shaft. This allows auger to turn freely on the shaft
preventing damage to gear drive.
For Replacement:
1. Align shear bolt holes in auger with shear bolt
holes in the shaft.
2. Drive shear bolt through hole (if shear bolt was
broken this will drive remaining part from shaft).
3. Secure shear bolt with nut.
DISCHARGE CHUTE DEFLECTOR
Deflector must stay in selected position while throwing
snow.
Deflector must stay in selected position while throwing
snow.
To adjust, loosen then retighten hardware to desired
deflector drag force (Figure 16).
deflector drag force (Figure 16).
SERVICE AND ADJUSTMENTS
WARNING: AVOID INJURY. Read and
understand the entire Safety section before
proceeding.
understand the entire Safety section before
proceeding.
Figure 14
2
1
OS0486
1. Runner
2. Runner Hardware
2. Runner Hardware
Figure 15
1. Auger
2. Shear Bolts
2. Shear Bolts
1
2
OS6780
2
Adjusting
Hardware
Hardware
OS0113
Discharge Chute
Deflector
Deflector
Figure 16