Jasco 15114 Folheto
Risk of electric shock
• Do not use with an
extension cord
• Plug directly into a
GFCI protected
electrical outlet
• Unplug timer before
cleaning
• Fully insert plug
• Keep children away
Risk of fire
•
Do not use to
control appliances
that contain heating
elements (cooking
appliances, heaters,
irons, etc.)
•
Do not exceed
electrical ratings
WARNING
24 Hour Outdoor Timer Instructions:
1. Locate the segments around the outer edge of the timer’s dial. These
1. Locate the segments around the outer edge of the timer’s dial. These
segments, each representing 15 minutes, can be pushed out and away from
the edge of the dial (try using the tip of a pen or pencil). Conversely, segments
that have been pushed out can be easily pushed back in by hand. Be sure all
segments are pushed in before programming. Select a time period (or periods)
you want the appliance turned on, then push out ALL the segments that fall on
or within that time period. For example, to have the timer turn an appliance on
at 10PM and off at 2AM, push out the segments representing 10PM and 2AM,
and ALL the segments in between.
the edge of the dial (try using the tip of a pen or pencil). Conversely, segments
that have been pushed out can be easily pushed back in by hand. Be sure all
segments are pushed in before programming. Select a time period (or periods)
you want the appliance turned on, then push out ALL the segments that fall on
or within that time period. For example, to have the timer turn an appliance on
at 10PM and off at 2AM, push out the segments representing 10PM and 2AM,
and ALL the segments in between.
See Figure 1.
You may need to turn the dial clockwise to access the desired segments.
2. Rotate the timer’s dial clockwise until the pointer on the face of the dial points
to the current time of day. Note: daytime hours (from 6:30AM to 6:30PM) are
highlighted with a black background.
highlighted with a black background.
3. Set Timer / On switch to the
TIMER position. Make sure to push switch fully to
timer position you will feel the switch snap into place.
4. Plug the timer into an electrical outlet convenient to the lights to be controlled.
5. Plug the lights into the outlet on the bottom of the timer. Make sure that the
5. Plug the lights into the outlet on the bottom of the timer. Make sure that the
light is turned on. The lights will now turn on and off at the times you have set.
NOTE: To override the timer and use your lights normally, set the Timer / On
switch to the
switch to the
ON position. This will deactivate the timer’s control of the lights, but
the timer’s dial will still show the current time of day. To reactivate the timer’s
control of the lights set the timer’s Timer / On switch to
control of the lights set the timer’s Timer / On switch to
TIMER. In case of power
failure, reset the time of day as explained in step 2.
Not for permanent installation. Do not install or use this product for more
than a 90 day period per year. When used outdoors, plug only into a GFCI
protected receptacle. Receptacle should be mounted in an approved
“weatherproof while in use” type outlet box.
15102
15114
15114
Manual Revision 2
12-21-09
www.jascoproducts.com
Figure 1 - shows timer set to turn appliance ON at 10 PM and OFF
at 2 AM. Notice ALL segments between 10 PM and 2 AM have been
pushed out. Current time is 8:00 PM.
at 2 AM. Notice ALL segments between 10 PM and 2 AM have been
pushed out. Current time is 8:00 PM.
Current
Time
Current
Time
Current
Time