Husqvarna 10527STE Manual Do Utilizador

7

The tires on your snow thrower were overinfl ated at the fac-
tory for shipping purposes.  Correct and equal tire pres sure 
is important for best snow throwing performance.

•      Reduce tire pressure to 14-17 PSI.

NOTE: The multi-wrench provided in your parts bag may 
be used to install the chute rotater head.

1.    Place discharge chute assembly on top of chute base 

with discharge opening toward front of snow thrower.

2.    Position chute rotater head over chute bracket.  If nec-

 es sary, rotate chute assembly to align square and pin 
on un der side of chute rotater head with holes in chute 
brack et.

3.   With chute rotater head and chute bracket aligned, 

po si tion chute rotater head on pin and threaded stud 
of mounting bracket.

4.   Install 3/8 washer and locknut on threaded stud and 

tighten securely.

INSTALL CHUTE DEFLECTOR REMOTE CONTROL 
(See Figs. 8 and 9)
1.   Install remote cable bracket to discharge chute with

5/16-18 carriage bolt, 5/16 fl at washer and 5/16-18 
locknut as shown.  Tighten securely.

2.   Install remote cable eyelet to chute defl ector with

1/4-20 shoulder bolt, nylon friction washer and 1/4-20 
locknut as shown.  Tighten securely.

3.    Install spring hooks between hex nuts on chute rotater 

head and into hole in chute defl ector as shown.