Troy-Bilt 10030 Manual Do Utilizador

16

•

Lift the rear auger belt from the auger pulley, and 
slip the belt between the support bracket and the 
auger pulley. Repeat for the front auger belt. See 
Figure 20.

•

Replace both auger drive belts by following 
instructions in reverse order. 

•

If you placed plastic film under the gas cap earlier, 
remove it now.

•

Follow the first four steps of the instructions for 
servicing the auger belts.

•

Pull the idler pulley up and lift the belt off the wheel 
drive pulley and friction wheel disc. See Figure 19.

•

Back out the stop bolt until the support bracket 
rests on the auger pulley. See Figure 21.

•

Slip the belt between the friction wheel and drive 
disc. Remove and replace the belt. Reassemble 
following the instructions in reverse order.

NOTE: The support bracket must rest on the stop bolt
after the new belt has been assembled.

The rubber on the friction wheel is subject to wear and 
should be checked after the first 25 hours of operation, 
and periodically thereafter. Replace the friction wheel 
rubber if any signs of wear or cracking are found.

•

Drain the gasoline from the snow thrower, or place 
a piece of plastic under the gas cap.

•

Tip the snow thrower up and forward, so that it rests 
on the housing.

•

Remove the six self-tapping screws from the frame 
cover underneath the snow thrower. 

•

Remove the click pin that secures the left wheel to 
the axle and slide the wheel from the axle.

•

Remove the four screws securing the left drive 
cover to the frame. Remove the drive cover. See 
Figure 22.

•

Holding the friction wheel assembly, slide the hex 
shaft out of the left side of the frame. The spacer on 
the right side of the hex shaft will fall and the 
sprocket should remain hanging loose in the chain. 
See Figure 23.