Ryobi RYI2000T Manual Do Utilizador

14 — English

The 12 V DC receptacle is designed to charge vented 
wet lead acid batteries, not to jump start vehicles. Do not 
overcharge battery or leave battery unattended. 

The 12 V DC receptacle provides continuous charge. Do 
not overcharge battery or leave battery unattended. Doing 
so may cause damage to the battery. 

Do not use the generator to jump start vehicles. Doing 
so could result in damage to the vehicle or it’s electrical 
components.



  Using the battery clamps, connect the battery charging 

cable assembly to the battery terminal. Connect the 
red wire to the positive (+) terminal first, then connect 
the black wire to the negative (–) terminal. Make sure all 
connections are secure.

 

NOTE:  Be careful not to short across the terminals when 
installing. Shorting the terminals together can cause 
sparks, damage to the battery or generator, or even burns 
or explosions.



  Connect the battery charging cable assembly to the  

12 V DC receptacle.



  Start the generator.

 

NOTE:  The AC receptacles can be used while the DC 
receptacle is in use.



  The battery will become slightly warm to the touch while 

charging. This is normal and does not indicate a problem.

 

NOTE:  Only use battery charging cable assembly to 
charge vented wet lead acid batteries.



  When batteries become fully charged, disconnect 

the battery charging cable assembly from the battery. 
Disconnect the negative (black) wire first, then the positive 
(red) wire, being careful not to short across the terminals. 
Always abide by the safety warnings provided with the 
battery. 

 

NOTE:  Most batteries will be completely charged after 
30 to 120 minutes. However, it is highly recommended 
that you refer to your battery manufacturer’s instructions 
for specific charge times.



  Unplug battery charging cable assembly and store for 

later use.

See Figure 11.


  Put the on/off switch in the 

OFF  ( O ) position.



  Close the vent on the fuel cap. 



  Allow 30 minutes of “cool down” time before storing the 

machine.



  Pull the retractable handle out.



  Facing the back of the generator, grasp the folding handle 

firmly with one hand.



  Lift the generator toward you until it balances on the 

wheels.



  Turn around and pull the unit along behind you to the 

desired location. 



  Lower the generator until it sits securely on a flat surface.

When servicing, use only identical replacement parts. 
Use of any other parts may create a hazard or cause 
product damage.

Always wear eye protection with side shields marked to 
comply with ANSI Z87.1. Failure to do so could result in 
objects being thrown into your eyes, resulting in possible 
serious injury.

Keep the generator in a clean and dry environment where it 
is not exposed to dust, dirt, moisture, or corrosive vapors. 
Do not allow the cooling air slots in the generator to become 
clogged with foreign material such as leaves, etc.
Do not use a garden hose to clean the generator. Water 
entering the fuel system or other internal parts of the unit can 
cause problems that will decrease the life of the generator.
To clean the unit:


  Use a soft bristle brush and/or vacuum cleaner to loosen 

and remove dirt and debris.



  Clean air vents with low pressure air that does not exceed 

25 psi.



  Wipe the exterior surfaces of the generator with a damp cloth.