Yamaha MU80 Manual Do Utilizador
EFFECT EDIT MODE
95
When
V
ariation
is
set
set
to
Insertion:
Insertion:
NOTES
●
As with System above, the Part to which Distortion is applied is determined by the Distortion Part parameter in the Distortion section (page 91). Also, the Part to
which Variation is applied is determined by the Variation Send control in the Single Part controls (page 40).
●
As with System above, the effects cannot be properly heard unless the Reverb Send, Chorus Send and Variation Send parameters in the Single Part controls (pages
39…40) and the Reverb Return and Chorus Return parameters in the All Parts controls are set to appropriate values.
●
The stereo position of the effects is controlled by the Reverb Pan and Chorus Pan parameters. (See pages 87…88.)
●
You can set Reverb and Chorus to be routed in parallel or in serial, and you can determine the amount of Chorus that is sent to Reverb. This is done with the Send
Chorus to Reverb parameter (see page 89). When this is set to 0, Reverb and Chorus are in parallel routing. Higher values for each provide varying degrees of serial
routing.
DIST
rev send
cho send
distotion on/off
VAR
variation on/off
dry
distotion part
variation part
part1
REVERB
reverb return
chorus return
send chorus to reverb
part32
DRY LINE
PAN
PAN
reverb pan
chorus pan
OUT
Thick line indicates stereo signal.
EQ
Distortion can be
applied to only one
Part at a time.
applied to only one
Part at a time.
CHORUS
The variation effect can be
applied to only one Part
at a time.
applied to only one Part
at a time.
VARIATION CONNECTION = INSERTION
DIST
rev send
cho send
distotion on/off
VAR
variation on/off
dry
DIST
rev send
cho send
distotion on/off
VAR
variation on/off
dry
DIST
rev send
cho send
distotion on/off
VAR
variation on/off
dry
part A1
part A2