Yamaha MU50 Manual Do Utilizador

NOTE
Keep in mind that the Reverb effect must be properly enabled and set for this parameter to
work as intended. (See page 86.) Also, the parameters Reverb Send in Single Part control
(page 38) and Reverb Return in All Part control (page 41) must be set to appropriate values.

Range: 0 — 127

This determines the level of the selected drum sound that is sent to
the Chorus effect. A value of 0 results in a completely “dry” drum
sound, no matter how much Chorus is applied to the Drum Part.

NOTE
Keep in mind that the Chorus effect must be properly enabled and set for this parameter to
work as intended. (See page 88.) Also, the parameters Chorus Send in Single Part control
(page 39) and Chorus Return in All Part control (page 41) must be set to appropriate values.

Settings: off, on (when Variation Connection is set to INS);

0 — 127 (when Variation Connection is set to SYS)

This determines the level of the selected drum sound that is sent to the
Variation effect. A setting of off results in a completely “dry” drum
sound, no matter how much Variation is applied to the Drum Part.

NOTE
Keep in mind that the Variation effect must be properly enabled and set for this parameter to
work as intended. (See page 89.) Also, the Variation Send parameter in the Part controls must
be set to on. (See page 39.)

Range:

–64 — +63

This determines the cutoff frequency of the filter applied to the se-
lected drum sound, or the frequency point around which other fre-
quencies are filtered out. Lower cutoff values create a deeper, more
rounded tone, while higher values create a thinner, brighter tone.

Cutoff
Frequency

Low (–64)

High (+63)

Level