Nady Systems ENCORE1LTOG1 Manual Do Utilizador

1.  Unscrew the BATTERY COMPARTMENT COVER (17) and remove, exposing the

. Insert a fresh 9V ALKALINE BATTERY (19), observing the 

correct polarity as marked, and screw the cover back on to the microphone. 

Make sure the cover is screwed on completely. A fresh alkaline battery can 

last up to 16 hours in use, but in order to ensure optimum performance, it is 

recommended that you replace the battery after every 10 hours of use.

2.  Turn on the WHT by sliding the OFF/STANDBY/ON SWITCH (20) to the STANDBY 

position (transmitter on, audio muted) or the ON position (transmitter and audio 

both on). The BATTERY INDICATOR LED (21) will give a single quick flash, indicating

usable battery strength. In the case of a dead or low battery, the LED will either 

not go on at all or will stay on continuously, indicating that the battery should be 

replaced with a fresh one. To preserve battery life, turn the transmitter off when 

not in use.

3.  The microphone is now ready to use. Most or all of the RF LEVEL DISPLAY LEDs (4) 

on the Encore I receiver should now be lit, indicating a received signal from the 

transmitter. When ready to speak, slide the transmitter switch to the ON position. 

Adjust the volume of the receiver as per the Audio Output Microphone Connection

section of the above Encore I receiver instructions. The AF LEVEL LED DISPLAY (5) on 

the Encore I receiver will light up to 5 LEDs (4 green and 1 red) for all input 

signals. Occasional flickering on and off during use of the top red LED indicator in

this display is normal, however if the red LED stays on continuously, it means the 

signal is too loud and there is the possibility of overload distortion. Back off from 

the microphone until the red LED indicator only flickers on peaks.

7