Yamaha O2R Manual Do Utilizador

MIXING Display Functions

The DELAY display function is used to apply a small amount of delay to 
input or return signals to compensate for situations such as line or cabling 
delays or the gap between the record and playback heads (or circuitry) of 
your multitrack recorder. You can delay a signal from 0 to 2,600 
samples—at 44.1 kHz this is a delay of 0 to 59.0 ms and at 48 kHz it is a 
delay of 0 to 54.2 ms.

Delay can be applied to any of the input channels and the tape and effect 
return channels. The stereo input channels are always ganged together. The 
MIC/LINE and TAPE channels are set independently only when they are 
not linked together in GANG mode with the PAN function

If you use a digital cascade kit (CD8-CS) to connect more than four 02Rs 
together, you will need to use the DELAY display function to apply delay 
to the machines closest to the output. Set a delay value of 10 to 20 samples 
for each unit.

The digital cascade kit will automatically apply the correct amount of delay 
when you connect four or less 02Rs together. See “Cascade Configuration” 
on page 191 of the User’s Guide.

There are two pages to the DELAY

 

1/1 function. The first page, shown 

below, contains the Delay controls for MIC/LINE channels 1 to 24, and 
appears when one of these channels is selected.