Yamaha PSR-S500 Manual Do Utilizador

Setting Up

PSR-S500 Owner’s Manual

Connect the instrument’s USB terminal to the USB ter-
minal of a computer, and you can transfer performance
data and song files between the two (page 85). To use
the USB data-transfer features you’ll need to do the fol-
lowing:

• First, make sure the POWER switch on the instru-

ment is set to OFF, then use a USB cable to con-
nect the instrument to the computer. After making
the connections, turn the instrument’s power on.

• Install the USB MIDI driver on your computer.

Installation of the USB-MIDI driver is described on
page 90.

Turn down the volume by turning the [MASTER VOL-
UME] control to the left and press the [STANDBY/ON]
switch to turn on the power. Press the [STANDBY/ON]
switch again to turn the power OFF.

Backup data in the flash memory is loaded to the instru-
ment when the power is turned on. If no backup data
exists on flash memory, all instrument settings are
restored to the initial factory defaults when the power is
turned on.

Connecting to a Computer (USB Terminal)

Turning the Power On

• Even when the switch is in the “STANDBY” position, electricity is

still flowing to the instrument at the minimum level. When you are
not using the instrument for a long time, make sure you unplug the
AC power adaptor from the wall AC outlet.

CAUTION

• Never attempt to turn the power off when a “Writing..” message is

shown in the display. Doing so can damage the flash memory and
result in a loss of data.

CAUTION