Yamaha CLP295 Manual Do Utilizador
Appendix
CVP-409/407 Owner’s Manual
210
CVP-409 grand piano type: Keyboard Stand Assembly
CAUTION
• Be careful not to confuse parts, and be sure to install all
parts in the correct orientation. Please assemble in accor-
dance with the sequence given below.
dance with the sequence given below.
• Assembly should be carried out by at least two persons.
• Be sure to use the correct screw size, as indicated below.
• Be sure to use the correct screw size, as indicated below.
Use of incorrect screws can damage the stand.
• Be sure to tighten all screws upon completing the assem-
bly of each unit.
• To disassemble, reverse the assembly sequence given
below.
The CVP-409 grand piano type features an iAFC (Instru-
mental Active Field Control) effect. This produces sound
from the speaker located on the bottom face of the
Clavinova, enhancing the reverberation and spacious-
ness of the sound when you open the lid with the longer
stay (page 16).
In order to optimize the iAFC effect, please observe the
following:
• Perform the automatic adjustment after you turn on
mental Active Field Control) effect. This produces sound
from the speaker located on the bottom face of the
Clavinova, enhancing the reverberation and spacious-
ness of the sound when you open the lid with the longer
stay (page 16).
In order to optimize the iAFC effect, please observe the
following:
• Perform the automatic adjustment after you turn on
the power of the Clavinova for the first time, and after
each time you re-locate the Clavinova. (page 176)
each time you re-locate the Clavinova. (page 176)
• Do not block the speaker located on the bottom face
of the Clavinova.
1
Remove all parts from the box. Confirm that all
parts shown in the illustration are included.
parts shown in the illustration are included.
How to position the main unit
Spread a large soft cloth, such as a blanket, on the floor.
Place the unit on the cloth with the key cover closed
and the keyboard side on the bottom and lean the unit
against the wall so that the unit will not fall or slip.
Place a soft cloth against the wall to protect the instru-
ment and the wall from scratches.
Place the unit on the cloth with the key cover closed
and the keyboard side on the bottom and lean the unit
against the wall so that the unit will not fall or slip.
Place a soft cloth against the wall to protect the instru-
ment and the wall from scratches.
Have a Phillips-head (+) screwdriver ready.
TIP
Lean the unit against the
wall as shown at right.
wall as shown at right.
Legs
Pedal box
6
× 40 mm fixing
screws
× 12
AC power cord
Cord holder
6
× 20 mm fixing
screws
× 4
Main unit
CAUTION
Be careful not to pinch your fingers.
CAUTION
Do not place the main unit with
the rear side facing down.
the rear side facing down.
CAUTION
Do not lay the main unit upside
down on the floor.
down on the floor.
CAUTION
Do not position the main unit so
that its bottom is in contact
with floor.
that its bottom is in contact
with floor.
Be sure to position the keyboard side on the bottom.
Incorrect
Incorrect
Incorrect