Yamaha III Manual Do Utilizador

Utility Mode [UTILITY]

126

DTXTREME III Owner’s Manual

Pad Settings

[F2] PAD

1

Determines the amount of time it takes to detect a foot splash 
(from the start of a downward press to the opening of the hi-
hat controller). The smaller the value, the more narrow the 
“virtual” open position is.

B

Determines the length of time from the moment you apply a 
foot-splash performance to the Hi-Hat Controller to the 
moment the foot-splashed hi-hat sound is actually triggered. 
For larger values, you can play the foot-splashed sound more 
easily; however, slight movements of the pedal may trigger 
the sound inadvertently. It is a good idea to set this parameter 
to “off” if you do not play foot-splashes.

C

Determines whether or not the continuous change of the 
sound generated by opening/closing the Hi-Hit cymbal (by 
pressing/releasing the Hi-Hat Controller) is transmitted as 
MIDI messages via MIDI OUT.

From this display, you can assign functions other than trig-

gering the drum sound to the pad (Trigger Input Source).

1

Determines the Trigger Input Source to which the specified 
function is assigned. When Input Lock (page 79) is turned off, 
you can select the Trigger Input Source also by hitting the 
corresponding section of the pad.

B

Determines the function assigned to the Trigger Input Source 
specified above.

Off

No function is assigned. Normal operation. 

inc kitNo.

Hitting the pad increases the Drum Kit num-
ber by 1.

dec kitNo. Hitting the pad decreases the Drum Kit num-

ber by 1.

inc chain

Hitting the pad increases the Chain Step 
number by 1.

dec chain

Hitting the pad decreases the Chain Step 
number by 1.

inc tempo

Hitting the pad increases the value of the 
tempo by 1.

dec tempo Hitting the pad decreases the value of the 

tempo by 1. 

tap tempo Hitting the pad three times sets the tempo 

value even when the Tap display is not called 
up. 

clk on/off

Hitting the pad starts/stops Click playback. 

1

When this parameter is set to on, the DTXTREME III will not 
accept any Trigger Signals coming from all Trigger Input 
Sources. This parameter is useful when you want to cancel all 
Trigger Signals temporarily in order to change the pad con-
nection setup. This parameter should be set to off normally.

-32 – +32

off, 1 – 127

off, on

Refer to the Trigger Input Source List on 
page 61. 

1

2 3

2

1

• The Pad Function setting overcomes the Pad Song setting (page 93) 

if both of them are assigned to the same Trigger Input Source. 

See below.

off, on

1

Ref

erence

Dr
um Kit mode

Song mode

Clic

k mode

T

rigger mode

File mode

Utility mode

Chain mode

Sampling mode