Yamaha III Manual Do Utilizador

Setting Up

DTXTREME III Owner’s Manual

19

Connecting to Speakers or 
Headphones

Since the DTXTREME III has no built-in speakers, you’ll 
need an external audio system or a set of stereo headphones 
to properly monitor it. 

■

These jacks allow you to connect the DTXTREME III to an 
external amplifier/speaker system and produce full, ampli-
fied sound. 

• Use the DTXTREME III’s OUTPUT L/MONO jack 

when connecting to a device with a mono input.

■

The overall headphone level is adjusted by the PHONES 
slider. 

Connecting to External Audio 
Equipment

When recording your performance on a DTXTREME III 
Drum Kit or sending its sounds to a mixer, connect your 
equipment as follows:

The OUTPUT (L/MONO and R) and INDIVIDUAL OUT-
PUT (1 to 6) jacks produce line level audio signals regard-
less of whether headphones are connected or not. These 
jacks are mono phone type. To make audio connections via 
these jacks, use cables with a mono phone plug for the 
DTXTREME III and an appropriate plug for the other 
device.

Use both OUTPUT jacks (L/MONO and R) for stereo out-
put. If the other device has a mono input, use the L/MONO 
jack only.

The DIGITAL OUTPUT connector can be connected to a 
coaxial digital input (S/P DIF) on an external audio device. 
This connector digitally outputs stereo audio signals identi-
cal to those from the OUTPUT L/MONO and R jacks. 

External audio signals input to AUX IN/SAMPLING IN 
jack can be monitored together with the DTXTREME III 
sounds via headphones connected to the PHONES jack, 
and can be recorded to create additional User Voices. If 
necessary, you can use the [GAIN] knob on the rear panel 
to adjust the gain of the input signal.

• Whenever making connections, make sure that the plug on the cable 

being used corresponds to the type of jack on the device.

• Do not use the DTXTREME III at a high volume level for a long period 

of time, or your hearing may be damaged. Doing so may cause hearing 
loss.