Yamaha M3000-24 Manual Do Utilizador

About the Scene Memory function

In utility mode you can modify various settings 
related to scene memory operations. Operations such 
as Bulk Out and Bulk Dump Request are also per-
formed in this mode.

1. When the M3000 is in normal mode, press and 

immediately release the scene memory section 
UTILITY switch.

The UTILITY switch indicator will light, and the 
M3000 will enter utility mode. At this time, the MEM-
ORY display will alternately show the currently 
selected utility item and the current parameter value.

2. Press the UTILITY switch repeatedly until the 

desired item appears in the MEMORY display.

For the available items, refer to the section “Utility 
items” below.

3. Use the scene memory section 

▲

/

▼

 switches to 

modify the setting of the currently selected item.

For the available values of each item, refer to the sec-
tion “Utility items” below.

• If you select Bulk Out or Bulk Dump Request parame-

ters, or if you select the Memory Initialize parameter, 
the function will be executed when you press the 
STORE switch.

4. To exit utility mode, press and hold the UTILITY 

switch for one second or longer.

The M3000 will return to normal mode. If the display 
shows “

” (bulk request), you can also return to 

normal mode by pressing the UTILITY switch once 
again.

Utility mode includes the following items and param-
eter settings.

This indicates the voltage of the internal battery. If the 
voltage drops to 2.5V or less, the indicator will show 
“

” and the voltage alternately. If an abnormal volt-

age occurs, the indicator will show “

” and “

” 

alternately. If either of these displays appears, immedi-
ately contact your dealer or a Yamaha service center to 
have the battery replaced.

This is a memory protect function to prevent impor-
tant data from being overwritten. When this is turned 
on, it will not be possible to modify or save scene data. 
Also, even if a bulk dump is received from an external 
MIDI device, the contents of memory will not be 
rewritten.

This changes the operation of the DIRECT RECALL 
1–8 switches. When this is set to “

,” the DIRECT 

RECALL 1–8 switches will function as direct recall 
switches which directly recall memory numbers 1–8. 
When this is set to “

,” the DIRECT RECALL 1–8 

switches will function as mute group switches to add/
defeat mute groups 1–8. (For details on mute groups, 
refer to page 36.)

This erases all scene memories (ALL) or an individual 
scene memory (1–128). After selecting 

“

”  or  “ ” 

~ “

,” press the STORE switch to erase the speci-

fied scene memory(s). Be aware that once a scene 
memory is erased, it cannot be recovered.

This specifies the MIDI channel on which MIDI mes-
sages will be transmitted and received via the MIDI 
IN/OUT connectors.

........................................................ oFF/on/LoC
This specifies whether or not program changes will be 
transmitted and received via the MIDI IN/OUT con-
nectors. If this is set to “

,” program changes will 

not be transmitted or received. If this is set to “

,” 

program changes 0–127 received from an external 
device will select scenes 1–128 that were saved in the 
M3000’s scene memory. (However if the oP parameter 
is set to “

,” incoming program changes 0–7 will be 

ignored.) Also, when a scene for which data has been 
saved is recalled by an operation on the M3000, the cor-

Note: If you continue holding the UTILITY switch 
for approximately one second or longer, you will 
exit utility mode and return to normal mode.