Yamaha M2500 Manual Do Utilizador

Control panel

These output channels control the signals of AUX 
buses 7–14 or GROUP buses 1–8. You can use the 
GROUP/AUX FLIP switch (page 14) to select the sig-
nals that will be controlled.

■ GROUP/AUX FLIP switch= GROUP (

The signals of AUX buses 7–14 will be sent to chan-
nels A7/G1–A14/G8 respectively, and will be output 
individually from the AUX/GRP OUT A7/G1–A14/
G8 jacks.

■ GROUP/AUX FLIP switch= AUX (

The signals of GROUP buses 1–8 will be sent to chan-
nels A7/G1–A14/G8 respectively, and output individ-
ually from the AUX/GRP OUT A7/G1–A14/G8 jacks.

A

LEVEL control

This adjusts the output level of AUX/GRP OUT A7/
G1–A14/G8. The “▲” position is nominal level.

B

ON switch

This turns AUX/GRP OUT A7/G1–A14/G8 on/off. 
When the switch is on (

), the signals from the A7/

G1–A14/G8 section will be output from the AUX 
OUT A7/G1–A14/G8 jacks respectively.

C

AFL switch

This switch is used to monitor the signal from the 
AUX/GRP OUT A7/G1–A14/G8 section via the 
MONITOR OUT/PHONES jacks. If all the input 
channel PFL switches are off, you can turn on this 
AFL switch to monitor the corresponding signal of 
the A7/G1–A14/G8 section from the MONITOR 
OUT/PHONES jacks. You can use the MASTER PFL 
switch of the monitor section to switch the monitor 
signal between pre/post-fader (LEVEL control).

1

2

3