Yamaha 02R Manual Do Utilizador

Controls and Connections

This is a push-type power switch. It is recessed to prevent 
accidental operation. Press once to power ON; press again to 
power OFF.

This 15-pin Dsub connector sends the meter information from each 
of the input channels, tape and effect return channels, auxiliary 
channels, etc., to the optional meter bridge (MB02).

This RCA/phone jack is a nominal –10 dB/10k

Ω

 connector. It 

accepts standard SMPTE time code to synchronize the 02R to an 
external time code generator.

This is a standard 5-pin DIN-type MIDI connector. It is used to 
connect the 02R to a MIDI time code source for external 
synchronization.

The COAXIAL output is an RCA/phono jack. It outputs the main 
stereo signals for recording, and can be connected to DAT, MD, 
and DCC digital recorders via a 75

Ω

 coaxial cable. The output 

format is IEC958 Part 2 (S/PDIF - Consumer).

The AES/EBU output is an XLR-3-32 type connector. It also 
outputs the main stereo signals for recording. The output format is 
IEC958 Part 3 (AES/EBU - Professional).

These are standard 5-pin DIN-type MIDI THRU, OUT, and IN 
connections. They are used to connect the 02R to external MIDI 
devices for sequencer synchronization and control.

These are TTL/75

Ω

 BNC connectors for transmitting (OUT) and 

receiving (IN) word clock signals. A switch is provided to apply a 
75

Ω

 terminator to the signal if the 02R is the last device in the 

chain.

This 8-pin MiniDIN connector is to plug a Macintosh or PC into 
the 02R for dedicated external system control.

2TR IN DIGITAL (1) is an XLR-3-32 type connector. The input 
format is IEC958 Part 3 (AES/EBU - Professional).

2TR IN DIGITAL (2 and 3 ) are RCA/phono jacks. The input 
format is IEC958 Part 2 (S/PDIF - Consumer).