Yamaha 02R Manual Do Utilizador

Specifications

The automix memory has been corrected. Abnormal data may be gen-
erated in the memory if you turn off the power during recording or if in-
complete bulk data is received.

Time code frame is dropping out.
(The count in the parenthesis shows the number of dropping frames.)

Time code frame is dropping out.

Model ID for parameter change is not correct.

In/out time setting is incorrect.

The internal battery voltage is getting very low. Back-up the setup data 
stored in the 02R (see “Bulk Dump/Request” on page 145 of the User’s 
Guide), and ask your dealer to replace the battery.

Consult the nearest YAMAHA service center.

Consult the nearest YAMAHA service center.

Consult the nearest YAMAHA service center.

MIDI data being transmitted is too large.

MIDI data being received is too large.

Check the connection at the TO HOST connector.

Check the connection at the TO HOST connector.

Check the connection at the TO HOST connector.

Check the connection at the TO HOST connector.

Check the connection at the TO HOST connector.

Consult the nearest YAMAHA service center.

First make a New Mix.

Automix memory is full.

The device number of the received bulk data is not correct.

There is no AUX send from EFF1 to AUX7 or EFF2 to AUX8.

Time code is not being input.

You cannot store data to the preset memory.

The previous operation was redone.

You cannot store data to Scene “0.”

Scene memory is write-protected.

A channel for extract has not been assigned.

The parameter for extract has not been assigned.

Set the overwrite parameter.

The track is ready for solo.

You cannot change the solo status and the Solo key is disabled if the 
unit is a cascade slave.

Consult the nearest YAMAHA service center.

Consult the nearest YAMAHA service center.

Consult the nearest YAMAHA service center.

Consult the nearest YAMAHA service center.