Roland SPD-S Manual Do Utilizador
43
Chapter 2 Wave Editing
Chapter 2
Basic Operations for Wave Edit
This section describes the steps for setting wave parameters. Wave settings
are made using Wave Edit.
are made using Wave Edit.
1
Press [WAVE] so you are in wave mode.
2
Press [-]/[+] to select a wave.
3
Press [EDIT] to go into Wave Edit.
[EDIT] lights at this time.
4
Press PAGE buttons to select an item to be edited from those listed
below, and then press [ENTER].
To select another item after pressing [ENTER], press [EXIT].
For details on each item, see its reference page.
For details on each item, see its reference page.
•
WAVE SETUP
•
START/END POINT
• WAVE TRUNCATE
• WAVE PITCH
• WAVE CHOP
• WAVE COPY
• WAVE DELETE
• WAVE INFO (Wave Information)
• WAVE PITCH
• WAVE CHOP
• WAVE COPY
• WAVE DELETE
• WAVE INFO (Wave Information)
5
Press PAGE buttons to choose the parameter of an item.
6
While pressing [START/STOP] or hitting a pad to monitor the sound,
press [-]/[+] to change the parameter value.
7
Press [EXIT] and then repeat Steps 4 to 6 to continue Wave Edit
operations. Press [WAVE] to finish Wave Edit.
The SPD-S saves the settings (with “now writing..” indicated) and then
returns to the wave mode.
returns to the wave mode.
If you hold down [SHIFT] and
press [-]/[+], you can change
the wave number in steps of
10. If you hold down [+] and
press [-], or hold down [-] and
press [+], the wave number
changes quickly.
press [-]/[+], you can change
the wave number in steps of
10. If you hold down [+] and
press [-], or hold down [-] and
press [+], the wave number
changes quickly.
If you have selected
“I000 OFF” in Step 2 by
mistake, “cannot execute!” is
displayed and you cannot go
into Wave Edit.
“I000 OFF” in Step 2 by
mistake, “cannot execute!” is
displayed and you cannot go
into Wave Edit.
When there are any selectable
items, PAGE buttons ([<], [>],
or both) are lit.
items, PAGE buttons ([<], [>],
or both) are lit.
When it is necessary to press
[ENTER], it is flashing.
[ENTER], it is flashing.
If you have selected an a new
(empty) wave in Step 2, no
items other than WAVE COPY
and WAVE INFO are
indicated.
(empty) wave in Step 2, no
items other than WAVE COPY
and WAVE INFO are
indicated.
If you hold down [SHIFT] and
press [FUNC], the parameter is
reset to its initial value.
press [FUNC], the parameter is
reset to its initial value.
SPDS_e.book 43 ページ 2004年4月19日 月曜日 午前9時58分