Roland DR-3 Manual Do Utilizador
77
Chapter 8 Creating and Performing Songs ([SONG])
Ch
ap
ter
ap
ter
8
3. Press [ENTER] to determine the pattern
to be recorded.
The measure numbers advance automatically.
The asterisk (*) indicates that the pattern
displayed has not been confirmed. If you press
[EXIT] at this point, the pattern that has already
been set appears in the display. If no pattern has
been confirmed, “- - - -” is displayed. Once you
confirm the pattern, the asterisk disappears.
The measure numbers advance automatically.
The asterisk (*) indicates that the pattern
displayed has not been confirmed. If you press
[EXIT] at this point, the pattern that has already
been set appears in the display. If no pattern has
been confirmed, “- - - -” is displayed. Once you
confirm the pattern, the asterisk disappears.
4. Press [
] [
] to change the step to
be recorded.
5. Repeat Steps 2–4 as needed to record the
data for the song.
6. To stop recording, press STOP [
].
The STEP REC [
] goes out.
*
Note that pressing START [
] during Step
Recording (while STEP REC [
] is lit) switches the
DR-3 to Realtime Recording.
Erasing Previously Recorded Sounds
As You Continue Recording
As You Continue Recording
You can use the following procedure to delete the
displayed pattern.
displayed pattern.
1. Press [
] [
] to display the pattern to
be deleted.
2. Hold down STEP REC [
] and press
[ENTER].
The pattern is deleted, and the subsequent
patterns are shifted forward.
The pattern is deleted, and the subsequent
patterns are shifted forward.
■ When Using Realtime Recording
The sounds are recorded as the patterns are
switched with the pads.
switched with the pads.
*
When recording over a song that has already been
recorded, the newly recorded data overwrites the
previously recorded data, which is discarded.
recorded, the newly recorded data overwrites the
previously recorded data, which is discarded.
Make sure you have pressed [SONG] to switch to
Song mode.
Song mode.
1. Hold down STEP REC [
] and press
START [
].
fig.08-02d-1
2. Turn the VALUE dial to select the style,
and press a pattern pad to specify the
first pattern to be recorded.
Recording begins from the pattern specified.
The Song Recording screen appears.
first pattern to be recorded.
Recording begins from the pattern specified.
The Song Recording screen appears.
fig.08-05d
3. Perform by switching the patterns with
the pattern pads.
Perform exactly as in Style Manual mode (p. 43).
The ON/OFF status of the VARIATION
[PTN], [KIT] and [MUTE] (p. 45) is also
recorded.
You can also change styles by turning the
VALUE dial.
Perform exactly as in Style Manual mode (p. 43).
The ON/OFF status of the VARIATION
[PTN], [KIT] and [MUTE] (p. 45) is also
recorded.
You can also change styles by turning the
VALUE dial.
*
If you switch the style during its performance, a “
”
mark appears in front of the style name which will be
played next. The style switches after the currently
played next. The style switches after the currently
playing pattern ends, and the “
” mark disappears.
*
The ON/OFF status of the VARIATION buttons and
fill-ins can be recorded only in a unit of pattern.
fill-ins can be recorded only in a unit of pattern.
4. When you press [ENDING/STOP], the
ending is played, and then both the
performance and the recording stop.
If you want to stop the recording
performance and the recording stop.
If you want to stop the recording
immediately, press STOP [
].
Measure
Pattern Name
Style No.
Song No.