Raymarine ST60 Manual Do Utilizador
Chapter 3: Installation
19
Although this provides a useful alternative method for securing your instrument,
it is only suitable for use in positions where the instrument will not be exposed to
water.
it is only suitable for use in positions where the instrument will not be exposed to
water.
To bracket mount your ST60 instrument, do so in accordance with the Control Unit
Mounting Bracket Instruction Sheet.
Mounting Bracket Instruction Sheet.
Fitting transducers
If you are fitting an ST60 Wind instrument and wish to use it as a master
instrument, you must also fit a wind transducer.
instrument, you must also fit a wind transducer.
Note:
An ST60 Close Hauled Wind instrument can only be used as a repeater instrument,
so a directly-connected transducer is not required.
Typical windvane installation
Note:
Do NOT remove the connector cap from the wind vane base connector, until you are
ready to fit the wind vane arm.
The wind vane base must be horizontal. If necessary, make up a suitable packing
piece to provide a horizontal mounting surface.
piece to provide a horizontal mounting surface.
D6954-1
Rotavecta
Wind vane
Typical transducers
Packing piece, if required
D6868-2