Raymarine ST60 Manual Do Utilizador

24

ST60 Wind & Close Hauled Wind Instrument Owner’s Handbook

The ST60 Wind instrument and the ST60 Close Hauled Wind instrument can each 
be connected to SeaTalk, as repeater instruments. 

The ST60 Wind instrument, can also be connected:
• As a stand-alone instrument connected directly to the wind transducer.
• To fulfil both repeater and master roles by being connected both to the trans-

ducer and to SeaTalk.

Instruments connected to SeaTalk derive their power directly from SeaTalk and no 
separate power connection is necessary. Where a SeaTalk system includes an 
autopilot, the power for the system is provided by the autopilot.

A range of Raymarine SeaTalk extension cables is available to connect separated 
instruments. These cables are supplied with a SeaTalk connector fitted to each 
end. A junction box can be used to join cables.

Make the necessary connections to your ST60 instrument (see the 

Connection to 

ST60 Wind instrument

 illustration). Although all possible connections are shown:

• You can connect only one transducer type (either Rotavecta or Wind Vane), to 

an ST60 Wind instrument. Do NOT attempt to connect both types, even if both 
are fitted.

If at any time, the transducer type is changed (e.g. a Wind Vane is connected in 

place of a Rotavecta), use the procedures in Chapter 4, Calibration to apply the factory de-
fault settings, then carry out the linearization and alignment procedures.

• The ST60 Close Hauled Wind instrument can only be connected to SeaTalk; it 

does not have transducer connectors.