Edirol UA-1000 Manual Do Utilizador

 

This selects the sampling frequency at which audio data will be recorded and played back.

In order for this setting to take effect, you must exit all applications and turn the power of the UA-1000 off, then on 
again.

The sampling frequency select switch must be set to match the sampling frequency of the application you are using. 
If you are using external clock mode, this must also match the sampling frequency of your external device.

 

• ADAT mode switch

• External clock switch

• Sampling frequency select switch

• STEREO/MONO select switch

• Direct monitor soft control switch

• Output volume select switch

• Monitor mixer and patch bay settings

To call up the settings stored in USER SET, set the 

 

 to 

 

, then cycle the 

power to the unit.

For more about the internal monitor mixer and patch bay, refer to 

 

 

This selects whether the input signal will be monitored in stereo or in monaural.

Even if 

 

 is selected, the audio signal sent via USB to your computer is stereo.

Turning off the power of the UA-1000 will not change the setting of this switch.

If you have connected a mic or guitar to only one of the 

 

, it is convenient to use the 

MONO setting.

 

This selects whether the INPUT MONITOR will be controlled by your software. When lit, the monitor volume, pan, 
and on/off settings of each input jack can be controlled from your software. When unlit, signals will be output 
without being affected by any settings of the INPUT MONITOR.

This lets you temporarily disable the settings of your software in order to check the state of connections.

For details on controlling the UA-1000 from your computer, refer to 

 

Turning off the power of the UA-1000 will not change the setting of this switch.

 

 

fig.0db

 

This adjusts the volume at which the input signal is sent to the INPUT MONITOR. If you set the knob 
to the 

 

 position, the volume will be the same as the signal that is being recorded.

 

If this knob is turned all the way to the left, the signal level sent to the INPUT MONITOR will be 

 

.

If you are “thru-ing” the audio data within your computer, or have connected a mixer and are 
outputting the input signal directly from the mixer for monitoring, leave this knob turned all the way 
to the left.

You can adjust the 

 

 even when the 

 

 is turned 

off.

UA-1000_e.book 13 ページ ２００３年８月６日　水曜日　午前１１時５２分