Roland HPi-6s Manual Do Utilizador

 

Error Message

 

* External Media: USB memory and floppy disk etc.

* Press [

] button, and you can cancel the error message.

 

You can only read the music file. It can not be saved.

 

An error occurred during writing. 
The storage media’s protect tab may be in the “Protect” (writing prohibited) position, or the storage media may 
not yet be initialized.

 

No storage media is inserted.
Insert the storage media and try again.

 

There is not sufficient free memory in the save destination. 
Either insert other storage media or delete unneeded files and try again.

 

An error occurred during writing. The storage media may be corrupted. 
Insert other storage media and try again. Alternatively, you can initialize the storage media.

 

The file is unreadable. The data format is not compatible with the HPi-6S.

 

Data was not called up in time for playback of the song. 
After waiting several seconds, you may be able to play back the song by pressing the [

(Play/Stop)] button 

again.

 

The selected image data cannot be displayed. 
Prepare image data that can be used with the HPi-6S (p. 92).

 

This audio format is not supported.
Please use 44.1 kHz 16-bit linear WAV format audio files.

 

The internal memory capacity of the HPi-6S is full.

 

The HPi-6S cannot deal with the excessive MIDI data sent from the external MIDI device. 
Reduce the amount of MIDI data sent to the HPi-6S.

 

A MIDI cable has been disconnected. 
Connect it properly and securely.

 

A MIDI transmission error has occurred. 
Check the MIDI cable and connected MIDI device.

 

There may be a problem with the system. 
Repeat the procedure from the beginning. If it is not solved after you have tried several times, contact the Roland 
service center.

 

The External Memory connector was subjected to excessive current. 
Make sure that there is no problem with the external media, then turn the power off, then on again.

HPi-6S-e.book 114 ページ ２００７年１１月１９日　月曜日　午前１０時３６分