Boss Audio Systems PS-6 Manual Do Utilizador

Changing the Battery

When the CHECK indicator goes dim or no longer

lights while an effect is on, it means that the battery

is nearly dead and must be replaced.

Replace the battery following the steps below.

* Since this device consumes a considerable amount of

power, we recommend that you use an AC adaptor. If

using batteries, please use alkaline batteries.

Thumbscrew

Battery Housing

Pedal

Spring Base

Coil Spring

Guide Bush

Hole

Battery Snap Cord

Battery

Snap

9 V Battery

1. Loosen the thumbscrew at the front of the

pedal, then lift the pedal upwards to open the

unit.

* The thumbscrew can be left in the pedal while changing

the battery.

2. Remove the old battery from the battery

housing, and remove the battery snap connected

to it.

3. Connect the battery snap to the new battery, and

place the battery inside the battery housing.

* Be sure to carefully observe the battery’s polarity (+

versus -).

4. Slip the coil spring onto the spring base on the

back of the pedal, then close the pedal.

* Carefully avoid getting the snap cord caught in the coil

spring.

5. Finally, insert the thumbscrew into the guide

bush hole and fasten it securely.