Roland LX-10F Manual Do Utilizador

 

Before You Play

 

Before connecting cables to the bottom panel (the back 

edge of the LX-10F’s bottom), you’ll need to remove the rear 

board upper.

To remove the rear board upper, remove the three screws 
from the locations shown in the illustration.

 

Connecting the Speaker Cable

 

Plug the speaker cable extending from the stand into the 

speaker connector located at the rear of the LX-10F’s bottom 

panel.

Pay attention to the shape of the speaker cable’s connector, 

and insert it until you hear it click securely into place.

 

fig.SpeakerCable.eps

 

Connecting the Pedal Cord

 

Plug the pedal cord extending from the stand into the Pedal 

connector located at the rear of the LX-10F’s bottom panel.

 

fig.PedalCord.eps

 

Connecting the Power Cord

 

• Make sure that the [Power] switch is off (p. 16).

• Make sure that the [Volume] slider is minimized (p. 17).

 

fig.PowerCord.eps

 

You must use the power cord included with the LX-10F.

 

Opening/Closing the Lid

 

To open the lid, use both hands to lift it lightly.

The lid of the LX-10F is designed to close softly even if 

you remove your hands from it. However, it will close 

quite abruptly if it has been opened only slightly. Be 

careful not to pinch your fingers in the gap.

 

Getting Ready to Play

LX-10F_e.book 14 ページ ２０１０年１月１４日　木曜日　午後１０時４５分