Roland V-Synth GT Manual Do Utilizador

 

fig.06b-80.eps

 

* This setting applies to all tracks 

(Track A–D).

OFF, ON

This turns the multi step modulator on/off.

 

This indicates the current location within the step sequence.

 

This graphically shows the sixteen steps. The step bar shown at the far right 
(number 17) is the same as the one that appears at the far left (number 1). 
This is helpful when you’re setting up a looping sequence.

 

If you touch < SMOOTH >, the graph will become a (smooth) line graph.
If you touch < STEP >, the graph will become a bar graph.

 

Use these knobs to input the sixteen steps.

 

The V-Synth GT’s E1–E8 knobs correspond to knobs 1–8 and 9–16. To 
switch between 1–8 and 9–16, hold down [SHIFT] and use [

] [

] 

(the frame in the screen will move). According to how you turn the knob, 
the effect will be shown as a graph of 1--16 steps, and the color will 
change.

 

fig.06b-85.eps

 

When the cursor is at a step knob, you can hold down [SHIFT] and turn 
the VALUE dial to simultaneously modify the value of all steps.

 

* This setting applies to all tracks 

(Track A–D).

Off

The step sequence will not be reset when a note-on occurs.

Part

The step sequence will be reset when a note-on occurs, but will not be reset 
if the key was played legato.

Voice

The step sequence will be reset each time a note-on occurs.

Step Indicator

Step Bar

Multi Step Modulator Switch

V-Synth-GT_e.book 144 ページ ２００７年４月９日　月曜日　午後１時４６分