Yamaha MOTIF XS7 Manual Do Utilizador

The following optional devices can be installed to the 
MOTIF XS. 

Before installing the optional hardware, make sure you 
have a Philips screwdriver and ample space to work. 

• Before beginning installation, switch off the power to the 

instrument and connected peripherals, and unplug them from 
the power outlet. Installation or removal of any devices should 
be started ONLY after the instrument (and the optional 
hardware) returns to normal room temperature. Then remove all 
cables connecting the instrument to other devices. (Leaving the 
power cord connected while working can result in electric 
shock. Leaving other cables connected can interfere with work.)

• Be careful not to drop any screws inside the instrument during 

installation. (This can be prevented by keeping the optional 
units and cover away from the instrument while attaching). If this 
does happen, be sure to remove the screw(s) from inside the 
unit before turning the power on. Loose screws inside the 
instrument can cause improper operation or serious damage. If 
you are unable to retrieve a dropped screw, consult your 
Yamaha dealer for advice.

• Install the optional units carefully as described in the procedure 

below. Improper installation can cause shorts which may result 
in irreparable damage and pose a fire hazard.

• Do not disassemble, modify, or apply excessive force to board 

areas and connectors on optional units. Bending or tampering 
with boards and connectors may lead to electric shock, fire, or 
equipment failures. 

• It is recommended that you wear gloves to protect your hands 

from metallic projections on optional units and other 
components. Touching leads or connectors with bare hands 
may cause finger cuts, and may also result in poor electrical 
contact or electrostatic damage. 

• Be careful of static electricity. Static electricity discharge can 

damage the IC chips on the mLAN16E2. Before you handle the 
optional mLAN16E2, to reduce the possibility of static electricity, 
touch unpainted metal parts or a ground wire on the devices 
that are grounded. 

• Handle the optical units with care. Dropping or subjecting them 

to any kind of shock may cause damage or result in a 
malfunction. 

• Do not touch the exposed metal parts in the circuit board. 

Touching these parts may result in a faulty contact. 

• Be careful not to misplace any of the screws. 

• Do not use any screws other than what are installed on the 

instrument. Use of incorrect screws can cause damage. 

mLAN16E2

DIMMs

POWER
ON/

OFF

AC IN

THRU

MIDI

OUT

IN

PH ONES

PH

ONES

ASSIGNABLE

SUSTAIN

FOOT SWITCH

FOOT CONTROLLER

2

1

ASSIGNABLE OUTPUT

OUTPUT

R

R

L

L/MONO

DIGITAL OUT

A/D INPUT

R

L

GAIN

LCD CONTRAST

ETHERNET

USB

TO DEVICE

TO HOST

MOTIF XS6

MOTIF XS7

Rear cover for the mLAN16E2

Rear cover for the mLAN16E2

MOTIF XS6

MOTIF XS7

MOTIF XS8

Bottom cover for the DIMM

Bottom cover for the DIMM

Bottom cover for the DIMM