Yamaha GranTouch Manual Do Utilizador

1.  IMPORTANT NOTICE: DO NOT MODIFY THIS UNIT!

This product, when installed as indicated in the instructions contained in this manual, meets FCC requirements. Modifications not expressly approved by Yamaha 
may void your authority, granted by the FCC, to use the product.

2. IMPORTANT: When connecting this product to accessories and/or another product use only high quality shielded cables. Cable/s  supplied with this product 

MUST be used. Follow all installation instructions. Failure to follow instructions could void your FCC authorization to use this product in the USA.

3. NOTE: This product has been tested and found to comply with the requirements listed in FCC Regulations, Part 15 for Class “B” digital devices. Compliance with 

these requirements provides a reasonable level of assurance that your use of this product in a residential environment will not result in harmful interference with 
other electronic devices. This equipment generates/uses radio frequencies and, if not installed and used according to the instructions found in the users manual, 
may cause interference harmful to the operation of other electronic devices. Compliance with FCC regulations does not guarantee that interference will not occur 
in all installations. If this product is found to be the source of interference, which can be determined by turning the unit “OFF” and “ON”, please try to eliminate 
the problem by using one of the following measures:

Relocate either this product or the device that is being affected by the interference.

Utilize power outlets that are on different branch (circuit breaker or fuse) circuits or install AC line filter/s.

In the case of radio or TV interference, relocate/reorient the antenna. If the antenna lead-in is 300 ohm ribbon lead, change the lead-in to coaxial type cable.

If these corrective measures do not produce satisfactory results, please contact the local retailer authorized to distribute this type of product. If you can not locate 
the appropriate retailer, please contact Yamaha Corporation of America, Electronic Service Division, 6600 Orangethorpe Ave, Buena Park, CA 90620

The above statements apply ONLY to those products distributed by Yamaha Corporation of America or its subsidiaries.

IMPORTANT: The wires in this mains lead are coloured in accordance 

with the following code:

          BLUE         :  NEUTRAL

          BROWN     :  LIVE

As the colours of the wires in the mains lead of this apparatus may not 

correspond with the coloured markings identifying the terminals in your 

plug proceed as follows:

The wire which is coloured BLUE must be connected to the terminal 

which is marked with the letter N or coloured BLACK.

The wire which is coloured BROWN must be connected to the terminal 

which is marked with the letter L or coloured RED.

Making sure that neither core is connected to the earth terminal of the 

three pin plug.

CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE 
BLADE OF PLUG TO WIDE SLOT, FULLY INSERT.

ATTENTION: POUR ÉVITER LES CHOCS ÉLECTRIQUES, 
INTRODUIRE LA LAME LA PLUS LARGE DE LA FICHE DANS LA 
BORNE CORRESPONDANTE DE LA PRISE ET POUSSER 
JUSQU’AU FOND.