Yamaha H11 Manual Do Utilizador

ENGLISH

Keyboard Stand Assembly

H11 Owner’s Manual

• Be careful not to confuse parts, and be sure to install all 

parts in the correct direction. Please assemble the unit in 
the appropriate sequence.

• Assembly should be carried out by at least two persons.

• Be sure to use the included screws only, and insert screws 

of the correct size in the correct hole locations. Do not 
use any other screws. Use of incorrect screws can cause 
damage or malfunction of the product.

• Be sure to tighten all screws upon completing assembly 

of each unit.

• To disassemble, reverse the assembly sequence.

Locate two pads (F) so that they will be posi-
tioned about 30 cm inside from the left and right 
edges of A.

Place A on top of the pads.

Raise A to the vertical position, with the keyboard 
side on the bottom, and hold A securely.

Do not tip A further than 90 degrees to avoid stress to the 
key cover and lid.

Remove all parts from the box. Confirm that all parts shown in the illustration are provided.

6 x 30 mm long screws  x 4

Before starting installation, remove the vinyl ties that 
bundle the pedal cord and AC power cord.

6 x 20 mm short screws  x 10

4 x 6 mm small screws  x 6

Remove two rectangle pads (800 x 130 mm) from the 
packing box.

Be careful not to pinch your 
fingers when setting the instru-
ment on the floor.

Cord holders  x 4

You can attach the included cord holders and tuck 
in the LAN cable to suit your setup situation.

Do not position the pad under the 
control panel.

pads

30 cm

30 cm

Do not release A 
until you finish 
Step 4.