Yamaha 9000 pro Manual Do Utilizador

Sampling

Sampling

■ Pre Effect
You can set up a maximum of three DSP effects to be applied to the source sound as it 
is sampled. The DSP blocks are connected in series as shown below. The following dis-
play will be shown in step #10 on page 40. 

Importing Wave Files from Disk

To import previously saved waveform files via the PSR-8000 or standard WAV or AIFF 
format files from disk, insert the appropriate disk into the 9000Pro floppy disk drive, 
then press the [FILE IMPORT] LCD button in step #3 in "Basic Procedure" on page 
86.  

Clearing Wave Data

The explanations here apply to step #4 of the Basic Procedure on page 86.

Change the balance between the 
direct (dry) and effect (wet) sound.

Select the desired 
DSP block. 

Select the desired 
type of the selected 
DSP block. 

Select the parameter and adjust the 
value of the selected parameter. 
Note that the contents of the parameter 
may be different depending on the 
selected DSP type. 

Select this to call up the 
storing display. 

Press this button to 
switch between the cur-
rently selected wave and 
the currently selected 
panel voice.

Select this and press the 
[NEXT] button to call up the 
display that imports the 
wave data sampled via the 
PSR-8000.

Select this and press the 
[NEXT] button to call up the 
display that imports the 
WAV or AIFF format file. 

Select this to execute the 
Clear operation. 

Press this button to switch 
between the currently 
selected wave and the cur-
rently selected panel voice.

85