Yamaha 9000 pro Manual Do Utilizador

Installing Optional Hardware

Reference

187

-[3] Holding both edges of the SIMM module, raise it to the vertical

position until it firmly locks in place with the left and right clamps.

....................................................................................................................

-[4] After confirming the orientation, insert the second SIMM into

the front slot (the slot closest to the 9000Pro keyboard), and
raise it to the vertical position in the same way as the first
SIMM.

Replace the SIMM cover and attach it to the 9000Pro with
the six screws.

Check that the installed SIMMs are functioning properly.

Set the 9000Pro right-side up, and connect the power cord to the rear-panel
AC INLET jack and an AC outlet.
Turn on the power, go to the SAMPLING display (page 41), and check that
the REMAIN TIME value matches the amount of installed memory, as fol-
lows:

• 4MB x 2

106.9s

• 8MB x 2

202.1s

• 16MB x 2

392.3s

• 32MB x 2

772.7s

• No SIMMS

11.8s

(These values apply when there is no data in the wave memory.)

Clamp

CAUTION

• Make sure that the entire

length of the SIMM is evenly
inserted.

Second SIMM

Black screws

SIMM cover

• Although the wave memory of

the 9000Pro can be expanded
to 65 megabytes, the maxi-
mum size of a single sample
recording is 32 mega bytes
(380 sec.).

■

Removing SIMMs

SIMM modules can be removed after opening the clamps
at both ends of the connector slot.

185