This section describes the parameters used to configure the compressor applied to all of the Per-
formances on your CP5 or CP50. These settings are made via the Master Compressor screen,
which contains seven pages.

Edit Sequence

[Press and hold the [MASTER COMPRESSOR] button (for at least one second)



Navigate to the required page using the [

PAGE] and [PAGE

] buttons



Turn Knobs

1 to 3

Page

On-screen name

(and full name)

Description

LowTh
(Low Threshold)

This parameter is used to set the input-signal level at which the compressor starts
to process the sound in the low-frequency band.
Setting values: -54dB to -6dB

LowAtk (Low Attack)

This parameter is used to set the amount of time that elapses between arrival of an
input signal and activation of compression in the low-frequency band.
Setting values: 1ms to 200ms

LowRat (Low Ratio)

This parameter is used to set the compression ratio for the low-frequency band.
Setting values: 1.0 to 20.0

LowGain (Low Gain)

This parameter is used to set the output level of the low-frequency band.
Setting values: -∞ to +18dB

MidTh
(Mid Threshold)

This parameter is used to set the input-signal level at which the compressor starts
to process the sound in the mid-frequency band.
Setting values: -54dB to -6dB

MidAtk (Mid Attack)

This parameter is used to set the amount of time that elapses between arrival of an
input signal and activation of compression in the mid-frequency band.
Setting values: 1ms to 200ms

MidRat (Mid Ratio)

This parameter is used to set the compression ratio for the mid-frequency band.
Setting values: 1.0 to 20.0

MidGain (Mid Gain)

This parameter is used to set the output level of the mid-frequency band.
Setting values: -∞ to +18dB

HiTh
(High Threshold)

This parameter is used to set the input-signal level at which the compressor starts
to process the sound in the high-frequency band.
Setting values: -54dB to -6dB

HiAtk (High Attack)

This parameter is used to set the amount of time that elapses between arrival of an
input signal and activation of compression in the high-frequency band.
Setting values: 1ms to 200ms

HiRat (High Ratio)

This parameter is used to set the compression ratio for the high-frequency band.
Setting values: 1.0 to 20.0

HiGain (High Gain)

This parameter is used to set the output level of the high-frequency band.
Setting values: -∞ to +18dB

DivFrqL
(Dividing Frequency
Low)

This parameter is used to set the low-to-mid frequency when splitting the sound
into three bands.
Setting values: 16Hz to 20kHz

DivFrqH
(Dividing Frequency
High)

This parameter is used to set the mid-to-high frequency when splitting the sound
into three bands.
Setting values: 16Hz to 20kHz

CmnRel
(Common Release)

Affecting all three compression bands, this parameter is used to set the amount of
time that elapses until the sound is no longer being compressed.
Setting values: 10ms to 3000ms