Yamaha CLP-100 Manual Do Utilizador

CLP-S308/S306: Keyboard Stand Assembly

CLP-370/340/330, CLP-S308/S306

Owner’s Manual

ENGLISH

CLP-S308/S306: Keyboard Stand Assembly

CAUTION

• Assemble the unit on a flat floor surface.
• Be careful not to confuse parts, and be sure to install all parts in the correct orientation. Please

assemble the unit in accordance with the sequence given below.

• Assembly should be carried out by at least two persons.
• Be sure to use only the included screws of the specified sizes. Do not use any other screws. Use of

incorrect screws can cause damage or malfunction of the product.

• Be sure to tighten all screws upon completing assembly of the unit.
• To disassemble the unit, reverse the assembly sequence given below.

Remove all parts from the package and make sure you have all of the items.

Have a Philips-head (+) screwdriver of the appropriate size ready.

Foamed styrol pads
Remove foamed styrol pads from the package, position
them on the floor, then place A on top of them.
Position the pads so that they will not hide the connectors
on the bottom of A.

Pedal cord

6 x 20 mm long screws x 10

6 x 16 mm short screws x 6

4 x 14 mm thin screws x 5

4 x 10 mm thin screws x 2

4 x 20 mm tapping
screws x 5

Headphone hanger

Headphone hanger

Cord holders x 2

Power cord

Assembly Parts

Connector panel

Protective
sheet

CAUTION

Please keep the protective sheet for later use. It will be used to
protect the keyboard from being scratched when the instrument
is transported. The protective sheet should be spread over the
entire keyboard before closing the key cover.