Yamaha PM5D-RH V2 Manual Do Utilizador

D LOCATE POINT

These buttons correspond to each locate point. Twenty 
locate points can be specified for MMC-compatible 
devices, and another twenty locate points can be sepa-
rately specified for RS422-compatible devices. When 
you click buttons 1–20, an MMC command or RS422 
command for moving to that locate point will be 
transmitted.

E Time code

This field indicates the time code that is specified for 
each locate point. To edit the time code, click the   
button located at the left to open the MMC/RS422 
LOCATE POINT window, and specify the new time 
code in hours/minutes/seconds/frames. (In the case of 
DENON format, use track/minute/second/frame units 
to specify the value.) You can also use the CAPTURE 
button located at the right to capture the time code 
being received by the PM5D.

F CAPTURE

This button captures the time code currently being 
received by the PM5D, and inputs it in the time code 
field. In the case of MMC, the time code source, frame 
rate, and offset time can be specified in the EVENT 
LIST screen (SCENE function). (

➥ p.177) In the case 

of RS422, the time data at that moment for the exter-
nal device being controlled will be captured.

Here you can remotely control various functions of a 
Yamaha DME series digital mixing engine.

A Component type selection area

Here you can select the type of DME series component 
that you want to control from the PM5D. When you 
click the   /   buttons at the left and right to select the 
type of component, the display in the central area of 
the screen will change accordingly. The following types 
of component can be selected.

Select the port connecting the PM5D and the DME 
series unit, and initiate or terminate communication.

Control the DME series unit’s graphic EQ from the 
PM5D.

Control the DME series unit’s parametric EQ from the 
PM5D.

An internal signal within the DME series unit is divided 
into six bands, and the output level, filter slope and 
type, and cutoff frequency etc. can be controlled for 
each band. This screen also lets you specify the cross-
over frequency at which the bands are divided.

Control the long delay and short delay functions of the 
DME series unit from the PM5D.

Specify the level of the signals sent from a specific input 
of the DME series unit to all outputs, or from all inputs 
to a specific output.

For each slot of the DME series unit, specify the out-
put level, delay time, and phase setting of each port.

B Component selection area

From the type of component you selected in 

1

, select 

the component that you want to control.

6

7

5

4

1

2

3