Yamaha PM5D-RH V2 Manual Do Utilizador

A Cooling fan vents

These are the vents for the DSP5D’s internal cooling 
fans (two locations). When placing the unit, take care 
that these vents are not obstructed.

B FAN switch

This switches the rotational speed of the DSP5D’s 
internal cooling fans between HIGH and LOW.
For normal use, set this to LOW. However if the 
DSP5D is in a location of high temperature or is out-
side in direct sunlight, set this to HIGH. You should 
also set this to HIGH if you feel that the panel is 
warmer than usual. 

C Mode switch

This switch is used when initializing the settings of 
internal memory, when updating the firmware in the 
future, and when setting the machine ID number.

D POWER LED

This will light if power is being supplied to the DSP5D.

E Grounding screw

For safe operation, be sure that the DSP5D is correctly 
grounded. The included power cable has a three-pin 
plug, and if the AC outlet is grounded, the DSP5D will 
be grounded appropriately. If the AC outlet you’re 
using is not grounded, you must be sure to connect 
this screw to a valid electrical ground. Correct ground-
ing will effectively eliminate noises such as hum and 
interference.

1

2

3 4

5