Yamaha PM5D-RH V2 Manual Do Utilizador

J Level meter

These peak level meters indicate the level of the output 
signal from the MONITOR OUT jacks. You can select 
the level detection point to be immediately before the 
delay that is provided on the MONITOR/CUE bus 
output (when the PRE DELAY button is on) or imme-
diately after the delay (when the POST DELAY button 
is on).

K MONITOR / CUE DELAY

Here you can make settings for the delay function pro-
vided on the MONITOR/CUE bus output. Use the 
knob to specify the delay time (0–1000 msec), and use 
the ON/OFF button to switch the delay on/off. If the 
ON/OFF button is on, the monitor signal and cue sig-
nal will be delayed by the specified time. The delay time 
units can be changed in the DELAY SCALE field found 
in each screen of the INPUT DELAY/OUTPUT 
DELAY function.

L MONITOR LEVEL

The level of the signal sent from the MONITOR OUT 
jacks is set by the level (digital) you adjust here together 
with the level (analog) adjusted by the MONITOR 
[LEVEL] knob on the top panel of the PM5D.

M MONITOR OUT

Switches the signal sent from the MONITOR OUT 
jacks on/off.

Here you can make settings and perform operations 
related to the Cue/Solo function.

A SOLO ON/OFF

This button selects either 
CUE mode or SOLO mode 
as the type of monitoring 
performed by the [CUE] key. 
When you turn this button 
on, a confirmation message 
will appear. Each mode 
operates as follows.

button is off)
The signal of the channel 
whose [CUE] key is pressed 
will be sent to the dedicated 
CUE bus, and monitored via 
the CUE bus from the CUE 
OUT jacks, MONITOR 
OUT jacks (if CUE INTERRUPTION is on), and 
PHONE jack. This mode lets you monitor the signal of 
a specific channel without affecting other buses.

When using Input Solo, the familiar “solo” function is 
enabled; only the signal of the channel whose [CUE] 
key is pressed will be sent to the MIX, MATRIX, and 
STEREO A/B buses, and other channels will be muted. 
When using Output Solo, only that channel will be on. 
The signal of a channel whose [CUE] key is pressed can 
also be monitored from the CUE OUT jacks, MONI-
TOR OUT jacks, and PHONES jack.

B CUE MODE

This button selects one of the following two possibili-
ties for when the [CUE] key of more than one channel 
is pressed.

All channels / DCA groups whose [CUE] key is on will 
be mixed for monitoring.

K

J

L

M

1

2

3