Yamaha PM5D-RH V2 Manual Do Utilizador

Here you can edit the EQ parameters of the selected input 
channel.

A Channel selection

Selects the input channel (input channel 1–48, STIN 
channel 1–4 L/R, FXRTN channel 1–4 L/R).

B Name

This is the name of the currently selected input chan-
nel. If the input channel is paired (or if a ST IN channel 
or FX RTN channel is selected), a heart symbol is dis-
played at the right. For an input channel, you can click 
this symbol to enable/disable pairing.

C EQ ON/OFF

Turns the EQ on/off for that channel.

D EQ LINK GROUP

Selects the EQ link group (1–8) to which the EQ of that 
channel belongs. EQ parameters are linked for input 
channels belonging to the same group.

E LIBRARY

This button accesses the INPUT EQ LIBRARY screen 
(

➥ p.289), where you can store/recall input channel 

EQ library settings.

F ATT (Attenuation)

This knob adjusts the amount of attenuation/gain 
immediately following AD conversion in a range of 
–96 dB to +24 dB. This is linked with the ATT knob in 
the ø/ATT 1-48 screen and ø/ATT STIN/FXRTN 
screen. The current value is displayed in the box 
located below the knob.

G EQ TYPE

Selects the type of EQ. Turning the TYPE I button on 
selects the algorithm used in the 02R series. Turning 
the TYPE II button on selects a newly developed algo-
rithm. TYPE II reduces the interference between bands.

H EQ graph

This graph shows the approximate response of the EQ 
parameters. The colored vertical lines indicate the 
FREQ (center frequency) of the band for the parame-
ter at which the cursor is located. (The color of each 
line matches the knob markings for each band.) The 
response curve will change when you edit the Q or 
GAIN of each band.

I Level meters

These meters indicate the peak levels before EQ and 
after EQ. If the signal clips before or after EQ, the 
OVER segment will light.

J EQ FLAT

This button resets the GAIN parameters of all bands to 
the default value (±0.0 dB). When you click this but-
ton, a confirmation message will appear.

K HPF (High Pass Filter)

The high pass filter located after attenuation and before 
EQ can be switched on/off, and you can adjust its cut-
off frequency. The cutoff frequency can be adjusted in 
a range of 20–600 Hz.

L Knobs

These knobs adjust the Q, FREQ (center frequency), 
and GAIN (amount of boost/cut) for each band.

M

If this button is on, the LOW EQ will function as a 
shelving-type EQ. The Q knob will disappear.

N

If this button is on, the HIGH EQ will function as a 
shelving-type EQ. The Q knob will disappear.

O LPF (Low Pass Filter)

If this button is on, the HIGH EQ will function as a 
low-pass filter. The Q knob will disappear, and the 
GAIN knob is used to switch the LPF on/off.

1

2

3

5

4

9

8

7

6

J

M

K

N O

L