Yamaha PM5D-RH V2 Manual Do Utilizador

The AD IN section AD-converts the signals that are input from the rear panel INPUT jacks 1–48 and ST IN jacks 1–4, and 
sends them to the input patch section. The structure of this section differs between the PM5D model and the PM5D-RH 
model.

A [+48V ON/OFF] switch

If this switch is on, +48V is supplied to the condenser 
mic or direct box connected to the INPUT jack 1–48.

B [PAD] switch

If this switch is on, the input level is attenuated by 
26 dB.

C [GAIN] knob

Adjusts the input sensitivity of the input channel. The 
range of adjustment is –34 dBu to +10 dBu (when the 
PAD switch is on) or –60 dBu to –16 dBu (when the 
PAD switch is off).

D [PEAK]/[SIGNAL] LED

The [SIGNAL] LED will light when the input level 
reaches 14 dB below nominal level (i.e., 34 dB below 
clipping level). The [PEAK] indicator will light when 
the signal reaches 3 dB below clipping level.

E [INSERT ON/OFF] switch

This switch enables/disables the INSERT IN/OUT jack 
located on the rear panel.

F ST IN [GAIN] knob

Adjusts the input sensitivity of the ST IN channel. The 
range of adjustment is –34 dBu to +10 dBu.

G ST IN [PEAK]/ST IN [SIGNAL] LED

The ST IN [SIGNAL] LED will light when the input 
level of the ST IN channel reaches 14 dB below nomi-
nal level (34 dB below clipping level). The ST IN 
[PEAK] indicator will light when the signal reaches 
3 dB below clipping level.

H [LAMP DIMMER] knob

This adjusts the brightness of the lamp connected to 
the LAMP connector.

5

3

2

1

4

7

8

6