Yamaha MGP32X Manual Do Utilizador
Appendix
MGP32X/MGP24X Owner’s Manual
48
Specifications
Electrical Characteristics
0 dBu = 0.775 Vrms, 0 dBV = 1 Vrms
Output impedance of signal generator (Rs) = 150 Ω
Output load impedance = 10 kΩ(TRS phone output), 600 Ω(XLR output)
Nominal fader position is 10dB lower than the maximum position.
All faders are set to nominal position when dedicated in the below.
Output impedance of signal generator (Rs) = 150 Ω
Output load impedance = 10 kΩ(TRS phone output), 600 Ω(XLR output)
Nominal fader position is 10dB lower than the maximum position.
All faders are set to nominal position when dedicated in the below.
*1 Noise is measured with a A-Weighting filter.
*2 Crosstalk is measured with a 1 kHz band pass filter.
*3 Maximum voltage gain is measured under the condition that all faders and GAIN knobs are at maximum.
*2 Crosstalk is measured with a 1 kHz band pass filter.
*3 Maximum voltage gain is measured under the condition that all faders and GAIN knobs are at maximum.
PAN/BAL knob is panned hard left or right.
European Models
Inrush Current based on EN 55103-1:2009
4.5A (on initial switch-on)
3.5A (after a supply interruption of 5s)
Conforms to Environments: E1, E2, E3 and E4
Inrush Current based on EN 55103-1:2009
4.5A (on initial switch-on)
3.5A (after a supply interruption of 5s)
Conforms to Environments: E1, E2, E3 and E4
UNIT
Frequency Response
20 Hz to 20 kHz
GAIN knob: min
Refer to the nominal output level @1 kHz
GAIN knob: min
Refer to the nominal output level @1 kHz
+0.5/-1.0
dB
Total Harmonic Distortion
(THD + N)
(THD + N)
STEREO OUT GAIN knob: min
output level: +14 dBu @20 Hz to 20 kHz
0.02
%
Noise
*1
CH INPUT MIC EIN (Equivalent Input Noise): Rs = 150 Ω
GAIN knob: max
-128
dBu
STEREO OUT STEREO master fader: nominal
Bus assign switch: off (All)
-87
dBu
GROUP OUT GROUP master fader: nominal
Bus assign switch: off (All)
-90
dBu
AUX SEND AUX master knob: nominal
CH mix control: min (All)
-82
dBu
STEREO OUT Residual output noise
-94
dBu
Crosstalk
*2
@1 kHz
Adjacent Input Between input channels
-74
dB
Input to Output STEREO OUT L, R
PAN knob: panned hard left or right
-74
dB
Maximum Voltage Gain
*3
@1 kHz
MONO CH Input MIC to CH INSERT OUT
60
dB
STEREO INSERT OUT
70
dB
STEREO OUT
84
dB
GROUP OUT
84
dB
MONITOR OUT
80
dB
PHONES OUT
69
dB
AUX SEND (PRE)
76
dB
AUX SEND (POST)
86
dB
MATRIX OUT
90
dB
STEREO CH Input to STEREO OUT
58
dB
GROUP OUT
58
dB
AUX SEND (PRE)
50
dB
AUX SEND (POST)
60
dB
TALKBACK Input to STEREO OUT
70
dB