Yamaha 02R96 Manual Do Utilizador

Chapter 19—Remote Control

These buttons are used to set and to locate to the eight Locate memories. Locate memories 
can be set on the Locate Memory page (see page 194). To set a locate memory on-the-fly, 
while holding down the [SET] button, press a LOCATE MEMORY [1–8] button. The 
02R96 must be receiving timecode in order to do this. Once set, the stored position can be 
located by pressing the corresponding button. If the button is pressed while the machine is 
stopped, the stored position is located. If the button is pressed while the machine is playing, 
the stored position is located and then playback continues from that position.

This button is used in conjunction with the LOCATE MEMORY [1–8], [IN], [OUT], and 
[RETURN TO ZERO] buttons to set the locate points.

The locate points can be set as follows.

Use the cursor buttons to select the parameters, and use the Parameter 
wheel, INC/DEC buttons, and [ENTER] button to set them.
MACHINE CONTROL/DAW CONTROL: When the MACHINE CONTROL option is 
on, the MACHINE CONTROL section controls external MMC machines, except when a 
DAW Remote layer is selected, in which case it controls the DAW. When the DAW CON-
TROl option is on, the MACHINE CONTROL section controls the DAW regardless of 
which Layer is currently selected.

LOCATE MEMORY 1–8: These time values determine the points that will be located 
when the LOCATe MEMORY [1–8] buttons are pressed. They can only be set while the 
MACHINE CONTROL option is on. Locate points can be specified in hours, minutes, sec-
onds, and frames, the frame range being dependent on the frame rate setting on the Time 
Reference page (see page 152).