Yamaha 02R96 Manual Do Utilizador

Chapter 2—Control Surface & Rear Panel

AD Input #1 is shown at the top; AD Inputs #17 and #18 below

A 

AD Inputs 1 through 16 feature balanced XLR-3-31-type connectors and balanced 1/4-inch 
phone jacks, both with a nominal input range of –60 dB to +10 dB. Phantom powering 
(+48 V) is supplied to the XLR-type connectors, with individual ON/OFF switches on each 
input. The phone jacks, which can also be used with unbalanced phone plugs, have priority 
over the XLR-type connectors, so when a phone plug is inserted, the XLR-type connector 
is disconnected. AD Inputs 17–24 feature balanced 1/4-inch phone jacks. AD Inputs can be 
patched individually to the Input Channels or Insert Ins. See “AD Input Section” on page 
39 for more information.

B 

These unbalanced 1/4-inch TRS phone jacks are used to insert external signal processors, 
etc., into AD Inputs 1 through 16. They are wired: sleeve–ground, ring–return, tip–send. 
The nominal signal level is +4 dB. Inserts can be turned on and off individually by using the 
INSERT ON/OFF switches. See “AD Input Section” on page 39 for more information.

A 

These balanced 1/4-inch TRS phone jacks, nominal output 
level +4 dB, output the analog Studio Monitor signal for 
monitoring in the actual studio. The source, which is 
selected by using the STUDIO buttons in the MONITOR 
section, can be Aux Send #7, Aux Send  #8, the Stereo Out, or Control Room. The output 

2

1

1

Male XLR plug

1 (ground)

3 (cold)

2 (hot)

1/4"  TRS phone plug

Tip (hot)

Ring (cold)

Sleeve (ground)

1/4"  phone plug

1/4"  phone plug

1/4"  TRS phone plug

Tip (send)

Tip (send)

Ring (return)

Sleeve (ground)

Sleeve (ground)

Tip (return)

Sleeve (ground)

2

1

3

4

5

6

1/4"  TRS phone plug

Tip (hot)

Ring (cold)

Sleeve (ground)